Kawasaki Concours Forum

Concours 1400 (C14) FAQ => C-14, aka Concours-14 GTR 1400 => Electrical => Topic started by: Makz58 on May 14, 2011, 02:26:32 PM

Title: Rear turn signals wire access
Post by: Makz58 on May 14, 2011, 02:26:32 PM

I guess the subject line say's it all. Where is the best place to access the rear signal light wires for connecting an AdMore lighting kit. Brake and running light access I found On Fred Hs site.  Sorry mods I put this in the wrong place. Joy of aging.

Title: Re: Rear turn signals wire access
Post by: Makz58 on May 15, 2011, 12:33:24 PM

No one??

Title: Re: Rear turn signals wire access
Post by: B.D.F. on May 15, 2011, 12:57:47 PM

I cannot verify this until tomorrow:

The wires you want are the Black / Yellow and Green (left turn signal) and Black / Yellow and Gray (right turn signal); these wires will feed into a pair of connectors in the rear of the bike. That info. is correct and from the schematic. I <believe> those wires are located behind the ECU, inside the black rubber boot at the very rear of the area under the bike's saddle. It looks like this:

(http://i45.photobucket.com/albums/f82/BDF08012008/BrakerelaywiringtobikeJPG.jpg)

Again, I cannot verify the position of these wires until tomorrow but it should be correct and you can test them with a meter or test light anyway.

Brian

Quote from: Makz58 on May 15, 2011, 12:33:24 PM

No one??

Title: Re: Rear turn signals wire access
Post by: rtarp1 on October 18, 2011, 07:31:48 AM

be careful with that admore lighting kit.  i installed one and the lights in the strip were out of sequence.  when hooked up correctly the brake lights were the wrong color.   check the lights on a battery first following the schematic.