« previous next »
  Go Down

Author Topic: Question on '10 onwards fuel tank cover  (Read 1589 times)

Offline Kwikasfuki

  • Full Member
  • ***
  • Posts: 104
  • Country: gb
    • Uk GTR Forum
Question on '10 onwards fuel tank cover
« on: March 26, 2012, 05:03:43 PM »

On the old models the storage compartment was on the tank, and on '10 model this has been replaced by a fuel tank cover. Does anyone know

  • How easy it is to remove the cover (looks like a few hex bolts)
  • Would a fuzeblock fit underneath?
Cheers

Logged

Offline cablebandit

  • Full Member
  • ***
  • Posts: 269
Re: Question on '10 onwards fuel tank cover
« Reply #1 on: March 27, 2012, 06:48:30 AM »
3 bolts.  Easy Peasy. 

You may be able to squeeze a Fuzeblock under there but I doubt it.  There is barely room for the Power Commander V and I believe that is shorter than the Fuzeblock.
Logged

Offline maxtog

  • Elite Member
  • ******
  • Posts: 8869
  • Country: us
  • 2011 Silver
Re: Question on '10 onwards fuel tank cover
« Reply #2 on: March 27, 2012, 05:07:25 PM »
Quote from: Kwikasfuki on March 26, 2012, 05:03:43 PM
On the old models the storage compartment was on the tank, and on '10 model this has been replaced by a fuel tank cover. Does anyone know

  • How easy it is to remove the cover (looks like a few hex bolts)
  • Would a fuzeblock fit underneath?

Super easy to remove.

Very little room under there.  You might want to just remove the sucker and check it out yourself.  Personally, I don't think there will be room.
Logged
Shoodaben (was Guhl) Mountain Runner ECU flash, Canyon Cages front/rear, Helibars risers, Phil's wedges, Grip Puppies, Sargent World seat-low & heated & pod, Muzzy lowering links, Soupy's stand, Nautilus air horn, Admore lightbar, Ronnie's highway pegs, front running lights, all LED, helmet locks, RAM Xgrip, Sena SMH10, Throttle Tamer, MRA X-Creen, BearingUp Shifter, PR4-GT, Scorpion EXO-T1200,etc
  Go Up
« previous next »