« Reply #3235 on: September 28, 2018, 10:02:29 AM »
I have never done it. Where is the best place to find a how-to?
I am not sure there is one. I looked it up in the factory manual, but it is so easy it is silly.
On the back of the throttle are two cables. The outside is the open and the inside is the shut. The shut rarely needs adjustment. So just loosen the small lock nut on the outer cable, and turn the large, rubber-coated nut 1/2 turn and test the play several times, and repeat until there isn't much left. Then tighten the lock nut down. That's it! You do want a LITTLE play, but not much. Make sure you test that the engine idle speed does NOT change with your adjustments and that if you turn the steering to the extremes it doesn't change either (otherwise you overtightened and didn't leave enough play). Play should be 2-3mm.
Logged
Shoodaben (was Guhl) Mountain Runner ECU flash, Canyon Cages front/rear, Helibars risers, Phil's wedges, Grip Puppies, Sargent World seat-low & heated & pod, Muzzy lowering links, Soupy's stand, Nautilus air horn, Admore lightbar, Ronnie's highway pegs, front running lights, all LED, helmet locks, RAM Xgrip, Sena SMH10, Throttle Tamer, MRA X-Creen, BearingUp Shifter, PR4-GT, Scorpion EXO-T1200,etc