Kawasaki Concours Forum
The C10, aka Kawasaki Concours - The Original => The Bike - C10 => Topic started by: Juanjoseramos on December 03, 2019, 08:46:01 PM
-
Hello everyone! So I was wondering what is the correct firing order for a ZG1000. If you were sitting on the bike I have the coil of the left going to cylinder 1 and 3 and the coil on the right is going to 2 and 4 is this correct because when it starts it backfires hard
-
I imagine the firing order is the same as the Concours 14 (except it has 4 coils), but you probably want to ask in the correct forum:
http://www.zggtr.org/index.php?board=5.0 (http://www.zggtr.org/index.php?board=5.0)
-
I want to move it move it....
-
The left coil goes to, I believe, the #1 and #4 cylinders. The right coil to #2 and #3.
Cylinders are numbered 1 - 4 from left to right.
Don't worry about the firing order, it takes care of it self as long as the coil wires are going to the right cylinder.
-
LEFT 1-4
RIGHT 2-3
POWER WIRES AS SHOWN ALSO..
-
LEFT 1-4
RIGHT 2-3
POWER WIRES AS SHOWN ALSO..
-
I want to move it move it....
You been into the cases already?
-
Always in the cases, Gary.
-
I'm pretty sure,
Left 4-1
Right 3-2 will work too. :)
I'm bored.............
-
Firing order is 1-3-2-4 where 1 is the leftmost cylinder when sitting on the bike.
-
Wasted spark firing coils for 1&4, 2&3, 2&3, 1&4
-
Wasted spark firing coils for 1&4, 2&3, 2&3, 1&4
;)
-
I think this revival is pretty much over, when read from top to bottom...
(https://i.imgur.com/8WsTL2tg.jpg)