The bike was completely serviced 2 months earlier to finding these symptoms. The valves were adjusted, cam chain adjusted, oil and filter changed, carbs cleaned, adjusted, synced, fresh coolant, new thermostat. It was running excellent, smooth and steady, no issues. Then over a few days I noticed it began to run warmer than usual, but never overheated. I checked the coolant it was full. Checked the cooling fan, it was working. It began to have more valve train noise, I saw it was full of oil, but didn't quiet down within a few seconds as it usually does as it is warming up. So, I "guessed" it may not be getting oil to the top end. As it would not take much for lower end to be normally lubricated, but the "Y" tube flow possibly obstructed and under feeding it with oil. So that was the last I did with it a few months ago.
I started off this post with a statement that should have been a question, and was also probably miss- titled, and if you read through all my comments, you can see I tried to clear that up.
So, what I am going to do is manually oil the camshafts, cam chain, and sprockets, just to be on the safe side, before I run the engine for the oil pressure test. If the pressure is correct, then I will manually remove the oil from the camshafts and run the engine again to see if the they are being lubricated as they should be.
So Steve, given the symptoms, What is your diagnosis?