Author Topic: Possible stem adjustment tool???  (Read 2495 times)

Offline bowtie39

  • Full Member
  • ***
  • Posts: 121
  • Country: us
Possible stem adjustment tool???
« on: May 12, 2011, 07:41:49 pm »
Looking thru latest CW and in Service section was a new tool by Motion Pro.  They have made a screwdriver/punch type device to use for adjusting shock-spring preload especially on dirtbikes when access prohibits a spanner.  Appears to do good for the shocks with a adjuster ring and a jam ring combo.  It's made with a tip that shouldn't mess up the stem ring slots and a heavy end for driving.  Motion Pro Shock Spanner Punch #08-0483 and maybe about $19.00.   Just a possibility???

Roger
'16 Moondust Gray....gone

Offline snarf

  • Arena
  • Full Member
  • ***
  • Posts: 827
  • Country: 00
Re: Possible stem adjustment tool???
« Reply #1 on: May 13, 2011, 01:12:35 pm »
Hey good find.  That looks like it just might do the trick and save a few dollars
2002 Conc
1986 Conc "The spirit of COG"

"We did not become the men that we are because we were Sailors, soldiers or cops; we became Sailors, soldiers and cops because of the men we are."

Offline Cholla

  • Arena
  • Full Member
  • ***
  • Posts: 361
Re: Possible stem adjustment tool???
« Reply #2 on: May 13, 2011, 01:40:50 pm »
IIRC McMaster-Carr has the proper tool for less $. I'm sure the collective will chime in here...I always use a Ford wrench and screwdriver.
Beware the Black Widows...Feared throughout the land!